LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 1980 >> 924 Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> PORSCHE Turbocharging System >> Removal & Installation >> Turbocharger Assembly >> Installation

Turbocharger Assembly: Installation

  1. Install components in reverse order of removal. Loosen Allen head bolts of the base before attempting to install turbocharger on engine. While positioning turbocharger against engine, push hose on turbocharger. Tighten mounting nuts of exhaust manifold and turbocharger and then the base.
  2. Always use new seals on oil lines. Make sure that round seal fits properly on pressure duct. Install both pressure ducts before tightening bolt. Tighten steering gear bolts to 14-17 ft. lbs. (1.94-2.35 mkg).
  3. Before starting engine for first time, prime turbocharger with lubricating oil for 15 seconds by pulling plugs off manifold pressure limiting switch and operating starter.
scientia non olet · About LEMON Manuals