All Models (Exc. 356B/C & 911E) Front

Check or adjust riding height with vehicle on level ground. Mark center of front wheel hub cap. Bounce vehicle several times to settle front suspension. Measure dimension "a" as shown in illustration. When riding height is properly set, dimension "b" is 4.25" (911 & 912) or 3.54" (914) less than dimension "a" ±.2". To adjust riding height, if not properly set, loosen or tighten adjusting screw on torsion bar until correct dimension is obtained. Bounce vehicle several times and recheck. Difference between right hand and left hand measurement may not be more than 0.2".