LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2010 >> Solstice Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Controls And Fuel - 2.0L - DTC P0243 To DTC P0690) >> DTC P0497 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
NOTE: Larger volume fuel tanks and/or those with lower fuel levels may require several minutes for the floating indicator to stabilize. Refer to J 41413-200  (J 41413-100) operation manual for detailed instructions in Evaporative Emission System Diagnosis . See Special Tools .
  1. Connect the J 41413-200  nitrogen/smoke hose to the J 41413-311  brass cone adapter. Disconnect the hose at the fuel cap end of the GE-41415-50  . See Special Tools . Connect the J 41413-311  to the disconnected hose on the GE-41415-50  . Install the GE-41415-50  filler neck end only to the vehicle.
  2. Seal the system with a scan tool and use the flow meter on the J 41413-200  (J 41413-100) calibrated to 0. 51 mm (0.020 in) to determine there is no leak in the EVAP system.
    • If a leak is detected, use the J 41413-200  (J 41413-100) to apply smoke to the EVAP system at the filler neck until the leak is located.
scientia non olet · About LEMON Manuals