Diagnostic Aids

WARNING: This page is about a different variant/trim than selected.

The charge air cooler (CAC) is connected to the turbocharger and to the throttle body by flexible ductwork that requires the use of special high torque fastening clamps. These clamps cannot be substituted. In order to prevent any type of air leak when servicing the ductwork, the tightening specifications and proper positioning of the clamps is critical and must be strictly adhered to.
Use a solution of dish soap and water in a spray bottle to pinpoint any suspected air leaks in the induction system and in the CAC assembly.
The BARO sensor is integrated within the ECM, and it has a port on the housing that allows it to sense the ambient pressure. A buildup of contamination at this opening may hinder the operation of the BARO sensor.