LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2010 >> Solstice Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Controls And Fuel - 2.0L - DTC P000A To DTC P0238) >> DTC P0096, P0097, P0098, or P0099 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
NOTE: Perform Step 1 of this verification procedure only if the ignition has been OFF for 8 hours or more.
  1. Ignition ON, observe the following scan tool parameters. The readings should be within 9°C (16°F) of each other.
    • IAT sensor
    • IAT sensor 2
    • Engine coolant temperature (ECT) sensor
  2. Engine idling, observe the scan tool IAT Sensor 2 parameter. The reading should be between -39 and +130°C (-38 and +266°F) depending on the current ambient temperature and the vehicle operating conditions.
  3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals