LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2010 >> Solstice Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Controls And Fuel - 2.0L - DTC P000A To DTC P0238) >> DTC P0087, P0088, or P0089 >> Component Testing >> Static Test

Static Test

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the harness connector at the high pressure fuel pump.
    2. NOTE: The DMM and test leads must be calibrated to 0 Ω in order to prevent misdiagnosis.
  2. Test for 0.35-0.6 Ω at 20°C (68°F) of resistance between low control circuit terminal 1 and high control circuit terminal 2.
    • If the resistance is less than 0.3 Ω or greater than 0.6 Ω, replace the high pressure fuel pump.
  3. Test for infinite resistance between each terminal and the high pressure fuel pump housing/case.
    • If not the specified value, replace the high pressure fuel pump.
scientia non olet · About LEMON Manuals