LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2010 >> Solstice Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L - Repair Instructions - On Vehicle) >> Valve Stem Oil Seal and Valve Spring Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Special Tool J 36017 & Valve Seal
    GM758364Courtesy of GENERAL MOTORS CORP.
  1. Using the J 36017  install the NEW valve seal. See Special Tools . Fully seat the seal onto the valve guide.
    2. Fig 2: Identifying Valve Springs
    GM1403902Courtesy of GENERAL MOTORS CORP.
  2. Install the valve spring.
    3. Fig 3: Identifying Valve Spring Keepers
    GM1403900Courtesy of GENERAL MOTORS CORP.
  3. Install the valve spring retainer.
  4. Compress the valve spring using the J 43649  . See Special Tools .
  5. Install the valve spring keepers.
    6. Fig 4: View Of Air Hose Adaptor
    GM758363Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the air hose from the adapter.
  7. Remove the air hose adapter from the spark plug hole.
    8. Fig 5: View Of J 43649 Valve Spring Compressor (Cylinder Head)
    GM1675271Courtesy of GENERAL MOTORS CORP.
  8. Remove the J 43649  from the cylinder head. See Special Tools .
  9. Install the spark plugs. Refer to Spark Plug Replacement .
    10. Fig 6: Identifying Camshaft Roller Followers
    GM758358Courtesy of GENERAL MOTORS CORP.
  10. Install the camshaft roller followers.
  11. Install the camshaft. Refer to Intake Camshaft and Valve Lifter Replacement  or Exhaust Camshaft and Valve Lifter Replacement .
  12. If used, remove the J 43653  .
  13. If removed, install the starter. Refer to Starter Replacement .
scientia non olet · About LEMON Manuals