LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2010 >> Solstice Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L - Repair Instructions - On Vehicle) >> Oil Level Indicator Tube Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Charge Air Cooler Hose & Clamp
    GM1717120Courtesy of GENERAL MOTORS CORP.
  1. Loosen the charge air cooler (CAC) outlet hose clamp (2) at the CAC outlet pipe.
  2. Loosen the CAC outlet hose clamp (1) at the throttle body.
  3. Remove the CAC outlet hose from the CAC outlet pipe and throttle body.
    4. Fig 2: Identifying Engine Wiring Harness Clip
    GM1717515Courtesy of GENERAL MOTORS CORP.
  4. Remove the engine wiring harness clip (1) from the oil level indicator tube bracket.
    5. Fig 3: Identifying Front & Rear Knock Sensor Clips
    GM1717513Courtesy of GENERAL MOTORS CORP.
  5. Remove the number 1 knock sensor (2) clip from the oil level indicator tube bracket.
    6. Fig 4: Identifying Engine Wiring Harness Clips
    GM1717517Courtesy of GENERAL MOTORS CORP.
  6. Remove the engine wiring harness clip (4) from the oil level indicator tube bracket.
    7. Fig 5: View Of Oil Level Indicator & Tube
    GM1717518Courtesy of GENERAL MOTORS CORP.
  7. Remove the oil level indicator tube bolt.
  8. Remove the oil level indicator tube and indicator.
scientia non olet · About LEMON Manuals