Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Oil Level Indicator & Tube

Courtesy of GENERAL MOTORS CORP.

Lubricate the oil level indicator tube O-ring seal with lubricant. Refer to Adhesives, Fluids, Lubricants, and Sealers .
Install the oil level indicator tube to the engine block.

CAUTION: Refer to Fastener Caution .

Fig 2: Identifying Engine Wiring Harness Clips

Courtesy of GENERAL MOTORS CORP.

Install the engine wiring harness clip (4) to the oil level indicator tube bracket.

Fig 3: Identifying Front & Rear Knock Sensor Clips

Courtesy of GENERAL MOTORS CORP.

Install the number 1 knock sensor (2) clip to the oil level indicator tube bracket.

Fig 4: Identifying Engine Wiring Harness Clip

Courtesy of GENERAL MOTORS CORP.

Install the engine wiring harness clip (1) to the oil level indicator tube bracket.

Fig 5: View Of Charge Air Cooler Hose & Clamp

Courtesy of GENERAL MOTORS CORP.

Install the CAC outlet hose to the CAC outlet pipe and throttle body.
Tighten the CAC outlet hose clamp (1) at the throttle body.
Tighten the CAC outlet hose clamp (2) at the CAC outlet pipe.
Tighten the clamps to 5 N.m (44 lb in).