LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2010 >> Solstice Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L - Repair Instructions - On Vehicle) >> Engine Oil Cooler Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Intake CMP Sensor & Air Inlet Screen Support
    GM1826449Courtesy of GENERAL MOTORS CORP.
  1. Drain the cooling system. Refer to Cooling System Draining and Filling (GE-47716) or Cooling System Draining and Filling (Static Fill-LNF) .
  2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement (SKY) or Air Inlet Grille Panel Replacement (Solstice) .
  3. Remove the intake camshaft position (CMP) sensor.
  4. Remove the air inlet screen support nuts and support.
    5. Fig 2: Identifying Radiator Outlet Hose Components
    GM1826444Courtesy of GENERAL MOTORS CORP.
  5. Reposition the radiator outlet hose clamp (2) at the thermostat housing.
  6. Remove the radiator outlet hose from the thermostat housing for access and removal of the oil cooler.
  7. Reposition the radiator outlet hose clamp (1) at the oil cooler.
  8. Remove the radiator outlet hose from the oil cooler.
  9. Remove the radiator outlet hose clip (3) from the bracket.
    10. Fig 3: Identifying Surge Tank Outlet Hose
    GM1826446Courtesy of GENERAL MOTORS CORP.
  10. Reposition the surge tank outlet hose clamp (1) at the oil cooler.
  11. Remove the surge tank outlet hose from the oil cooler.
    12. Fig 4: View Of Engine Oil Cooler
    GM1769545Courtesy of GENERAL MOTORS CORP.
  12. Remove the oil cooler bolts.
  13. Remove the oil cooler.
scientia non olet · About LEMON Manuals