LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2010 >> Solstice Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L - Repair Instructions - On Vehicle) >> Engine Mount Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Charge Air Cooler Hose & Clamp
    GM1717120Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  2. Loosen the charge air cooler (CAC) outlet hose clamp (2) at the CAC outlet pipe.
  3. Loosen the CAC outlet hose clamp (1) at the throttle body.
  4. Remove the CAC outlet hose from the CAC outlet pipe and throttle body.
    5. Fig 2: View Of Left Engine Mount
    GM1717064Courtesy of GENERAL MOTORS CORP.
  5. Remove the left engine mount upper nut.
  6. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    7. Fig 3: View Of Driver Side Engine Mount-To-Frame Lower Nut
    GM1717062Courtesy of GENERAL MOTORS CORP.
  7. Remove the left engine mount lower nut.
    8. Fig 4: View Of Passenger Side Engine Mount-To-Frame Lower Nut
    GM1717066Courtesy of GENERAL MOTORS CORP.
  8. Remove the right engine mount lower nut.
  9. Position an adjustable jack below the oil pan. Place a block of wood between the oil pan and the jack.
  10. Raise the engine using the adjustable jack until the engine mount can be removed.
    11. Fig 5: View Of Left Engine Mount
    GM1717064Courtesy of GENERAL MOTORS CORP.
  11. Remove the left engine mount.
scientia non olet · About LEMON Manuals