LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2010 >> Solstice Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L - Repair Instructions - On Vehicle) >> Engine Mount Bracket Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Mount Bracket
    GM1717065Courtesy of GENERAL MOTORS CORP.
  1. Position the engine mount bracket to the engine block.
  2. Install the engine mount bracket bolts until snug.
    3. CAUTION: Refer to Fastener Caution .
  3. Tighten the engine mount bracket bolts in the following sequence.
    1. Lower
    2. Upper front
    3. Upper Rear

      Tighten:  Tighten the bolts to 55 N.m (41 lb ft).

    4. Fig 2: Identifying Generator
    GM1717482Courtesy of GENERAL MOTORS CORP.
  4. Install the engine wiring harness terminal (3) to the generator.
  5. Install the engine wiring harness nut (1) to the generator.

    Tighten:  Tighten the nut to 20 N.m (15 lb ft).

  6. Position the engine wiring harness boot (2).
    7. Fig 3: Identifying Negative Battery Cables & Cable Components
    GM1717479Courtesy of GENERAL MOTORS CORP.
  7. Install the positive battery cable terminal (3) to the starter.
  8. Install the positive battery cable starter solenoid nut (2) to the starter.

    Tighten:  Tighten the nut to 10 N.m (89 lb in).

  9. Install the left engine mount. Refer to Engine Mount Replacement - Left Side .
  10. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  11. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals