LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2010 >> Solstice Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L - Repair Instructions - On Vehicle) >> Engine Flywheel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Flywheel & Bolt (Manual Transmission)
    GM1591936Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the flywheel, if equipped with a manual transmission.
  2. Install the flywheel bolts.

    Tighten:  Tighten the bolts to 53 N.m (39 lb ft) plus an additional 25 degrees using the J 45059  .

    3. Fig 2: View Of Flywheel (Automatic Transaxle)
    GM1578311Courtesy of GENERAL MOTORS CORP.
  3. Install the flywheel if equipped with an automatic transmission.
  4. Install the flywheel bolts.

    Tighten:  Tighten the bolts to 53 N.m (39 lb ft) plus an additional 25 degrees using the J 45059  .

    5. Fig 3: Identifying Engine Flywheel Holding Tool
    GM1825675Courtesy of GENERAL MOTORS CORP.
  5. Remove the J 43653  (1) from the engine block.
  6. Install the clutch, if equipped. Refer to Clutch Pressure and Driven Plate Replacement .
  7. Install the starter, if equipped with a manual transmission. Refer to Starter Replacement .
  8. Install the automatic transmission, if equipped. Refer to Transmission Replacement .
scientia non olet · About LEMON Manuals