LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2010 >> Solstice Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L - Repair Instructions - On Vehicle) >> Camshaft Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Camshaft Cover
    GM1825751Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the camshaft cover and bolts and tighten to 10 N.m (89 lb in).
  2. Attach the electrical harness at the rear of the camshaft cover.
  3. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement (SKY) or Air Inlet Grille Panel Replacement (Solstice) .
    4. Fig 2: View Of PCV Fitting, Bolt & Pipe
    GM1826800Courtesy of GENERAL MOTORS CORP.
  4. Install a NEW O-ring seal to the PCV fitting.
  5. Position the PCV pipe (with fitting), install the PCV fitting bolt to the turbocharger and tighten to 10 N.m (89 lb in).
    6. Fig 3: Identifying CPA Retainer & HO2S Connector & Clip
    GM1825750Courtesy of GENERAL MOTORS CORP.
  6. Install the HO2S electrical connector clip (2) to the camshaft cover.
    7. Fig 4: Identifying Engine Wiring Harness Clips
    GM1825746Courtesy of GENERAL MOTORS CORP.
  7. Install the ignition coils. Refer to Ignition Coil Replacement .
  8. Disconnect the engine wiring harness electrical connector from the evaporative emission (EVAP) canister purge solenoid valve.
  9. Install the engine harness clips (1, 2) to the camshaft cover.
    10. Fig 5: Identifying Engine Wiring Harness Clip
    GM1825748Courtesy of GENERAL MOTORS CORP.
  10. Install the engine wiring harness clip (1) to the camshaft cover.
    11. Fig 6: Identifying Intake & Exhaust CMP Actuator Solenoid Valve Connectors
    GM1825749Courtesy of GENERAL MOTORS CORP.
  11. Connect the engine wiring harness intake (2) and exhaust (1) electrical connectors to the camshaft position actuator solenoid valves.
  12. Install the air cleaner outlet. Refer to Air Cleaner Outlet Duct Replacement .
    13. Fig 7: Identifying Intake Manifold Cover Studs
    GM1825745Courtesy of GENERAL MOTORS CORP.
  13. Install the intake manifold cover studs (1) and tighten to 9 N.m (80 lb in).
  14. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals