LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2010 >> Solstice Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Mechanical - 2.0L - Repair Instructions - Off Vehicle (2 Of 2)) >> Engine Oil Cooler Installation

Engine Oil Cooler Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Oil Cooler
    GM1769545Courtesy of GENERAL MOTORS CORP.
    NOTE: The oil cooler cannot be flushed or otherwise cleaned of contamination. Replace the oil cooler if a mechanical condition is suspected that could cause the oil cooler to be contaminated.
  1. Install the oil cooler.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the oil cooler bolts and tighten to 25 N.m (18 lb ft).
scientia non olet · About LEMON Manuals