LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2010 >> Solstice Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Mechanical - 2.0L - Repair Instructions - Off Vehicle (2 Of 2)) >> Cylinder Head Installation >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Cylinder Head, Gasket & Bolts
    GM1825048Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not use any sealing material.
  1. Install the cylinder head gasket to the block.
  2. Install the cylinder head. Ensure the number 1 cylinder is at top dead center (TDC). The key on the crankshaft should be on top in the 12 o'clock position.
    3. Fig 2: Identifying Cylinder Head Bolt Tightening Sequence
    GM412510Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
    NOTE: Always use NEW cylinder head bolts.
  3. Install the cylinder head bolts.
    1. Tighten the bolts in sequence to 30 N.m (22 lb ft) .
    2. Tighten the bolts an additional 155 degrees in sequence using the J 45059:  meter .
    4. Fig 3: Locating Front Cylinder Head Bolts
    GM1825075Courtesy of GENERAL MOTORS CORP.
  4. Install the front cylinder head bolts and tighten to 35 N.m (26 lb ft).
scientia non olet · About LEMON Manuals