Special Tools
WARNING: This page is about a different variant/trim than selected.
- J 8087: Cylinder Bore Gauge
- J 45059: Angle Meter
For equivalent regional tools, refer to Special Tools
NOTE:
If crankshaft bearing failure is due to other than normal wear, investigate the cause. Inspect the crankshaft or connecting rod bearing bores.
Inspect the connecting rod bearing bores or crankshaft main bearing bores using the following procedure:
- Tighten the bedplate to specification using the J 45059: meter.
- Measure the bearing bore for taper and out-of-round using the J 8087: gauge.
- No taper or out-of-round should exist.