LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2010 >> Solstice Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Mechanical - 2.0L - Repair Instructions - Off Vehicle (2 Of 2)) >> Crankshaft Rear Oil Seal Installation >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Crankshaft Rear Oil Seal & Special Tool J 42067
    GM412495Courtesy of GENERAL MOTORS CORP.
  1. Remove excess sealer from seal recess.
  2. Lubricate the outside diameter of the new crankshaft seal with clean engine oil.
  3. Using the J 42067  , press the new crankshaft seal into the housing. See Special Tools . The J 42067  also establishes the depth of the seal in the crankshaft seal bore. See Special Tools . The seal should be flush to 0.5 mm (0.0197 in) deep.
scientia non olet · About LEMON Manuals