LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2010 >> Solstice Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Mechanical - 2.0L - Repair Instructions - Off Vehicle (2 Of 2)) >> Crankshaft Balancer Installation >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Crankshaft Balancer & Bolt
    GM1769524Courtesy of GENERAL MOTORS CORP.
    CAUTION: Ensure both components are aligned correctly or serious engine damage will occur.
  1. Install the balancer onto the EN-48585:  guide. Use care to properly align the keyway and flats on the balancer with the oil pump drive.
  2. Install the crankshaft balancer into the end of the crankshaft.
  3. Ensure that J 43653:  tool is installed and engaging the flywheel to prevent crankshaft rotation.
    4. CAUTION: Refer to Fastener Caution .
    NOTE: Always install a NEW crankshaft balancer retaining bolt.
  4. Install a NEW retaining bolt and tighten to 100 N.m (74 lb ft) plus 125 degrees using J 45059:  meter.
  5. Remove J 43653:  tool.
    6. Fig 2: Identifying Locking Tool
    GM2128100Courtesy of GENERAL MOTORS CORP.
  6. Install EN-48953:  locking tool (1) and tighten the bolts into the cylinder head to 10 N.m (89 lb in).
  7. Release the timing chain tensioner by applying 45 N.m (33 lb ft) counterclockwise torque to the crankshaft balancer bolt.
  8. Remove EN-48953:  locking tool.
scientia non olet · About LEMON Manuals