LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2010 >> Solstice Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls And Fuel - 2.0L - Repair Instructions) >> Repair Instructions >> Intake Air Pressure and Temperature Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Intake Air Pressure & Temperature Sensor Electrical Connector
    GM1826861Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine wiring harness electrical connector (2) from the intake air pressure and temperature sensor.
    2. Fig 2: View Of Intake Air Pressure & Temperature Sensor & Bolts
    GM1829737Courtesy of GENERAL MOTORS CORP.
  2. Remove the intake air pressure and temperature sensor bolts.
  3. Remove the intake air pressure and temperature sensor.
scientia non olet · About LEMON Manuals