LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2010 >> Solstice Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls And Fuel - 2.0L - Repair Instructions) >> Repair Instructions >> Intake Air Pressure and Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Intake Air Pressure & Temperature Sensor & Bolts
    GM1829737Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the intake air pressure and temperature sensor O-ring with clean engine oil.
  2. Install the intake air pressure and temperature sensor.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the intake air pressure and temperature sensor bolts and tighten to 2.5 N.m (22 lb in).
    4. Fig 2: View Of Intake Air Pressure & Temperature Sensor Electrical Connector
    GM1826861Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine wiring harness electrical connector (2) to the intake air pressure and temperature sensor.
scientia non olet · About LEMON Manuals