LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2010 >> Solstice Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls And Fuel - 2.0L - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying EVAP & Fuel Feed Pipes
    GM1825535Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the chassis evaporative emission (EVAP) line quick connect fitting (2) from the purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service .
    2. Fig 2: Identifying MAP Sensor Connector
    GM1825525Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the engine wiring harness electrical connector (1) from the EVAP canister purge solenoid.
    3. Fig 3: Identifying EVAP Canister Purge Solenoid Components
    GM1825560Courtesy of GENERAL MOTORS CORP.
  3. Remove the EVAP canister purge solenoid bolt (6).
  4. Remove the EVAP canister purge solenoid (5).
  5. Remove the EVAP canister purge solenoid O-ring seal (4), if necessary.
  6. Inspect for carbon release in the EVAP canister purge solenoid ports. If there is any loose carbon, replace the EVAP canister and any components necessary to remove the carbon particles.
scientia non olet · About LEMON Manuals