LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2010 >> Solstice Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls And Fuel - 2.0L - Repair Instructions) >> Repair Instructions >> Charge Air Cooler Coolant Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Charge Air Cooler Hose Clamp
    GM1717120Courtesy of GENERAL MOTORS CORP.
  1. Install the charge air cooler hose to the outlet pipe and the throttle body.
  2. Tighten the charge air cooler hose clamp (2) at the charge air cooler outlet pipe.
    3. CAUTION: Refer to Fastener Caution .
  3. Tighten the charge air cooler hose clamp (1) at the throttle body.

    Tighten:  Tighten the charge air cooler hose clamps to 5 N.m (44 lb in).

scientia non olet · About LEMON Manuals