LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2010 >> Solstice Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls And Fuel - 2.0L - Repair Instructions) >> Repair Instructions >> Charge Air Bypass Valve Solenoid Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Charge Air Bypass Valve Solenoid Tube
    GM1750413Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine wiring harness electrical connector from the charge air bypass solenoid.
  2. Reposition the charge air bypass solenoid vacuum hose clamp (5) at the turbocharger and remove the hose.
  3. Remove the charge air bypass solenoid vacuum hose from the turbocharger coolant feed hose clamps (4).
  4. Reposition the charge air bypass solenoid vacuum hose clamp (3) at the charge air cooler outlet pipe and remove the hose.
  5. Reposition the charge air bypass solenoid vacuum hose clamp (1) at the intake manifold and remove the hose.
  6. Remove the charge air bypass solenoid bolts (2).
    7. Fig 2: View Of Charge Air Bypass Solenoid
    GM1829748Courtesy of GENERAL MOTORS CORP.
  7. Remove the charge air bypass solenoid.
scientia non olet · About LEMON Manuals