LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2010 >> Solstice Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls And Fuel - 2.0L - Repair Instructions) >> Repair Instructions >> Camshaft Position Sensor Replacement - Exhaust >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Engine Wiring Harness Electrical Connector & ECT Sensor
    GM1826284Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine wiring harness electrical connector (4) from the exhaust camshaft position (CMP) sensor.
    2. Fig 2: Identifying CMP Sensor
    GM1578483Courtesy of GENERAL MOTORS CORP.
  2. Remove the CMP sensor bolt. (Intake CMP shown, exhaust CMP similar)
  3. Remove the CMP sensor.
scientia non olet · About LEMON Manuals