LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2010 >> G5 Base, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays & Gauges >> Diagnostic Information and Procedures >> Boost Gauge Malfunction >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the boost gauge.
  2. Ignition OFF, test for less than 5 ohms between the ground circuit terminal D and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify a test lamp illuminates when connected between the B+ voltage circuit terminal A and ground.
    • If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance. If the circuit tests normal, test or replace the BCM.
  4. Ignition OFF, connect the harness connector at the boost gauge.
  5. Ignition ON, verify that the boost gauge performs a self test by the gauge dial moving up to the 0 kPa (0 psi) mark.
    • If the boost gauge does not perform a self test, test the boost gauge signal circuit terminal C for a short to ground or an open/high resistance. If the circuit tests normal, replace the PCM.
  6. If all circuits test normal, replace the boost gauge.
scientia non olet · About LEMON Manuals