Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTC P0011, P0012, P0031, P0032, P0037, P0038, P0100, P0101, P0102, P0103, P0115, P0117, P0118, P0120, P0122, P0125, P0136, P0137, P0138, P0139, P0171, P0172, P0220, P0222, P0223, P0300-P0304, P0335, P0339, P0340, P0341, P0342, P0343, P0351-P0354, P0365, P0367, P0368, P0500, P2135, P2195, P2196, P2237, P2238, P2239, P2252, P2253, P2A00 are not set.
The intake air temperature (IAT) is colder than -10°C (+14°F).
The engine coolant temperature (ECT) is greater than 75°C (167°F).
The engine speed is less than 4,000 RPM.
The MAF sensor input is between 2.5 and 40 g/sec.
The engine is operating in Closed Loop.
The engine load is between 10-80 percent.
DTC P0420 runs once per drive cycle when the above conditions have been met.