Circuit/System Description

This diagnostic monitors the primary circuitry of individual ignition coils for the successful completion of an ignition event. The ignition trigger signal and ignition fail-safe input signal provide crucial information in the control of ignition system timing and the activation of the fail-safe function. Based on the initial timing angle, calculated from the crankshaft and the camshaft position signals, the powertrain control module (PCM) calculates the ignition trigger signal. The ignition trigger signal is then sent to the ignition control circuitry located in each ignition coil. The ignition control circuitry initiates the ignition dwell period by commanding the power transistor ON. When the PCM determines the proper time to provide spark, the PCM turns OFF the ignition trigger signal. In response to the PCM signal, the ignition coil control circuitry turns OFF the power transistor, producing a high voltage discharge from the secondary coil windings. After the spark has occurred, the control circuitry sends an ignition fail-safe input signal back to the PCM, confirming that an ignition event has taken place. If the ignition fail-safe input signal is not received by the PCM, a cylinder specific DTC will set. The ignition coils consist of the following circuits:

• The ignition 1 voltage circuit
• The ignition trigger control circuit
• The ignition fail-safe circuit
• The ground circuit