Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
- The DTC P2610 is not set.
- The ignition has been off continuously for greater than 7 hours.
- The battery voltage is greater than 10.5 volts.
- The engine coolant temperature is warmer than -10°C (+14°F) at engine start up.
- The IAT sensor is warmer than -10°C (+14°F) after engine start.
- The engine has been running for greater than 15 seconds.
- DTC P011B runs once per ignition cycle when the above conditions are met.