Diagnostic Aids
WARNING: This page is about a different variant/trim than selected.
- The circuit opening relays electrical contacts may be pitted or sticking. Replace the relay, if tapping gently on the relay, or wiggling the relay causes a change in the relays operation.
- The performance of the circuit opening relay may be affected by temperature. Check the relay after sitting outside overnight and after running the engine 30 minutes.
Use the following relay cavity table in order to locate the correct cavities to probe during diagnosis. The table layout corresponds to the cavity layout of the relay block.
Circuit Opening Relay
| Terminal Identification | |
|---|---|
| Relay Controlled Output | |
| Relay Switch B+ | |
| Relay Coil Ignition | Relay Coil Control |