Fastener Tightening Specifications

WARNING: This page is about a different variant/trim than selected.

Application	Specification
Application	Metric	English
Air Cleaner Case Bolt	7.0 N.m	62 lb in
Air Tube	10 N.m	7 lb ft
Battery Carrier Bolt	13 N.m	9 lb ft
Battery Clamp
Bolt	17 N.m	12 lb ft
Nut	3.5 N.m	31 lb in
Battery Terminal	5.4 N.m	48 lb in
Camshaft Bearing Cap Bolt to Camshaft Housing	16 N.m	12 lb ft
Camshaft Bearing Cap Bolt to Cylinder Head	27 N.m	20 lb ft
Camshaft Housing Bolt	27 N.m	20 lb ft
Camshaft Oil Control Valve Bolt	10 N.m	7 lb ft
Camshaft Position Sensor Bolt	10 N.m	7 lb ft
Camshaft Timing Exhaust Gear Bolt
With SST	39 N.m	29 lb ft
Without SST	54 N.m	40 lb ft
Camshaft Timing Gear Assembly Bolt	54 N.m	40 lb ft
Clutch Release Cylinder Assembly Bolt
Bolt A, B	12 N.m	9 lb ft
Bolt C	8.0 N.m	71 lb in
Connecting Rod Cap Bolt
1st	20 N.m	15 lb ft
2nd	Turn 90°
Chain Tensioner Plate Bolt	10 N.m	7 lb ft
Crankshaft Bearing Cap to Cylinder Block
1st	40 N.m	30 lb ft
2nd	Turn 90°
Crankshaft Position Sensor Bolt	10 N.m	7 lb ft
Crankshaft Pulley Bolt	190 N.m	140 lb ft
Cylinder Block Water Drain Cock	13-20 N.m	9-15 lb ft
Cylinder Head Bolt
1st	49 N.m	36 lb ft
2nd	Turn 90°
3rd	Turn 45°
Cylinder Head Cover Bolt	10 N.m	7 lb ft
Drive Plate and Ring Gear Bolt
1st	88 N.m	65 lb ft
2nd	Turn 90°
Drive Plate and Ring Gear Nut	28 N.m	21 lb ft
Engine Coolant Temperature	20 N.m	15 lb ft
Engine Hanger Bolt	43 N.m	32 lb ft
Engine Mounting Bracket RH to Engine Mounting Insulator RH
Nut A	95 N.m	70 lb ft
Nut B	52 N.m	38 lb ft
Bolt	95 N.m	70 lb ft
Engine Mounting Bracket RH Bolt	51 N.m	37 lb ft
Engine Mounting Insulator LH to Engine Mounting Bracket Bolt	52 N.m	38 lb ft
Engine Mounting Insulator LH to Body Bolt	56 N.m	41 lb ft
Engine Mounting Insulator RH to Body Bolt	52 N.m	38 lb ft
Engine Oil Pressure Switch Assembly	15 N.m	11 lb ft
Exhaust Manifold Nut	21 N.m	16 lb ft
Exhaust Manifold Stay Bolt	43 N.m	32 lb ft
Exhaust Manifold Stay Nut	43 N.m	32 lb ft
Fan Belt Adjusting Bar Bolt	19 N.m	14 lb ft
Fan Belt Adjusting Bar Nut	19 N.m	14 lb ft
Flywheel Sub-Assembly Bolt	49 N.m	36 lb ft
Front Engine Mounting Bracket Bolt	73 N.m	54 lb ft
Front Engine Mounting Insulator Bolt	81 N.m	60 lb ft
Ignition Coil Assembly Bolt	10 N.m	7 lb ft
Intake Manifold Nut	28 N.m	21 lb ft
Knock Control Sensor	20 N.m	15 lb ft
No. 1 Chain Tensioner Assembly Bolt	10 N.m	7 lb ft
No. 1 Chain Vibration Damper Bolt	21 N.m	16 lb ft
No. 1 Exhaust Manifold Heat Insulator Bolt	12 N.m	9 lb ft
No. 1 Generator Bracket Bolt	21 N.m	16 lb ft
No. 1 Oil Nozzle Sub-Assembly Bolt	10 N.m	7 lb ft
No. 1 Ventilation Case Bolt	10 N.m	7 lb ft
No. 1 Water By-Pass Pipe Bolt	21 N.m	16 lb ft
No. 2 Chain Vibration Damper Bolt
With SST	5.5 N.m	48 lb in
Without SST	10 N.m	7 lb ft
No. 2 Oil Pan Sub-Assembly Bolt	10 N.m	7 lb ft
No. 2 Straight Screw Plug	44 N.m	33 lb ft
Oil Drain Plug	37 N.m	27 lb ft
Oil Filter Bracket Bolt	26 N.m	19 lb ft
Oil Level Dipstick Guide Bolt	21 N.m	16 lb ft
Oil Pan Drain Plug	37 N.m	27 lb ft
Oil Pump Assembly Bolt	21 N.m	16 lb ft
Oil Pump Drive Shaft Gear Bolt	28 N.m	21 lb ft
Radiator Pipe Bolt	8.8 N.m	78 lb in
Radiator Reserve Tank Bolt	7.0 N.m	62 lb in
Radio Setting Condenser Bolt	10 N.m	7 lb ft
Rear Engine Mounting Bracket Bolt	65 N.m	50 lb ft
Rear Engine Mounting Insulator Bolt	52 N.m	38 lb ft
Stiffening Crankcase Assembly Bolt	21 N.m	16 lb ft
Spark Plug	20 N.m	15 lb ft
Stud Bolt to Crankcase	5.0 N.m	44 lb in
Stud Bolt to Cylinder Head
Bolt A	9.5 N.m	84 lb in
Bolt B	9.5 N.m	84 lb in
Stud Bolt to No. 1 Ventilation Case	10 N.m	7 lb in
Timing Chain Cover
Bolt A	26 N.m	19 lb in
Bolt B	51 N.m	38 lb in
Bolt C	51 N.m	38 lb in
Bolt D	10 N.m	7 lb in
Bolt E	26 N.m	19 lb in
Ventilation Valve Bolt	20 N.m	15 lb in
Water Inlet Bolt	10 N.m	7 lb in
Water Inlet Housing Bolt	21 N.m	16 lb in
Water Pump Bolt	24 N.m	17 lb in
Wire Harness Bracket to Cylinder Head	52 N.m	38 lb in