LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission - MVB 4 Speed) >> Repair Instructions - On Vehicle >> Vehicle Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Speed Sensor O-Ring
    GM2011792Courtesy of GENERAL MOTORS CORP.
  1. Coat a new O-ring with ATF WS and install it to the speed sensor.
    2. Fig 2: View Of Speed Sensor O-Ring
    GM2011792Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the speed sensor with the bolt and tighten to 5.4 N.m (48 lb in).
  3. Install the air cleaner case.
  4. Install the air cleaner cap sub-assembly.
  5. Install the No. 2 cylinder head cover.
scientia non olet · About LEMON Manuals