LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission - MVB 4 Speed) >> Repair Instructions - On Vehicle >> Range Selector Lever Cable Replacement >> Removal

Range Selector Lever Cable Replacement: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the cable from the negative battery terminal.
  2. Remove the front floor console assembly. Refer to Front Floor Console Replacement .
  3. Remove the battery.
  4. Remove the battery tray.
  5. Remove the engine cover assembly.
  6. Remove the air cleaner cap sub-assembly.
  7. Remove the oxygen sensor.
  8. Remove the center exhaust pipe assembly.
  9. Remove the air cleaner case sub-assembly.
    10. Fig 1: Identifying Floor Heat Insulator Nuts
    GM2012029Courtesy of GENERAL MOTORS CORP.
  10. Remove the front No. 1 floor heat insulator.
  11. Remove the 3 nuts (1) and the front No. 1 floor heat insulator.
  12. Remove the transmission control cable assembly.
  13. Move the shift lever to N.
    14. Fig 2: Identifying Transmission Control Cable Assembly & Shift Lever Assembly
    GM2011930Courtesy of GENERAL MOTORS CORP.
  14. Disconnect the end of the transmission control cable assembly (1) from the shift lever assembly.
    15. Fig 3: Identifying Transmission Control Cable Stopper
    GM2011931Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not remove the stopper. If the stopper is removed, reinstall it to its original position.
  15. Pull out the stopper of the transmission control cable.
    16. NOTE: Do not over-rotate the nut as it will come off the internal spring and the transmission control cable will not be reusable.
  16. Rotate the nut counterclockwise approximately 180 degrees, while holding the nut in that position, disconnect the transmission control cable from the shift lever retainer.
    17. Fig 4: Identifying Transmission Control Cable Assembly
    GM2012030Courtesy of GENERAL MOTORS CORP.
  17. Remove the nut (1) and disconnect the control cable assembly from the control shaft lever.
  18. Remove the clip and disconnect the transmission control cable assembly from the control cable bracket.
    19. Fig 5: Identifying Transmission Control Cable & Control Cable Bracket
    GM2012031Courtesy of GENERAL MOTORS CORP.
  19. Disconnect the control cable assembly (1) from the control cable bracket.
    20. Fig 6: Identifying Transmission Control Cable & Control Cable Support Nut
    GM2012035Courtesy of GENERAL MOTORS CORP.
  20. Remove the nut (1) and separate the transmission control cable support.
    21. Fig 7: View Of Transmission Control Cable Nuts
    GM2012037Courtesy of GENERAL MOTORS CORP.
  21. Remove the 2 nuts (1) and separate the transmission control cable assembly.
  22. Pull out the transmission control cable assembly.
scientia non olet · About LEMON Manuals