Circuit Description
WARNING: This page is about a different variant/trim than selected.
Shift solenoid valve ST is switched ON/OFF by a signal from the engine control module (ECM) so that letting in or out timing of the 2nd brake is adjusted by operating orifice control valve. Therefore, shift solenoid valve ST operates when letting in or out reverse clutch.
If the shift solenoid valve ST is broken, the shift shock becomes big.
When there is an open or short circuit in any shift solenoid valve circuit, the ECM detects the problem, and illuminates the MIL and stores the DTC. The ECM performs the fail-safe and turns on the other shift solenoid valves in good condition.