Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition ON, clear the DTC information with a scan tool. Observe the scan tool DTC information. Verify that DTC P0606 or P0607 does not fail this ignition cycle.
- If DTC P0606 or P0607 failed this ignition, test the PCM 5-volt reference circuit of the applicable engine sensors for a short to ground. Refer to Diagnostic Aids . If the circuits test normal, replace the PCM.
- Observe the DTC information with a scan tool. Verify DTCs P0604, P060A, P060D, P060E, or P2610 do not set this ignition cycle.
- If any of the DTCs set this ignition cycle, replace the PCM.