Blockage/Restriction Testing
WARNING: This page is about a different variant/trim than selected.
- Verify the following conditions do not exist in the EVAP system:
- A plugged or restricted EVAP filter
- A plugged or restricted air inlet pipe or hose
- If a condition is found repair or replace the affected component.
- Test the operation of the EVAP canister and EVAP vacuum leak pump assembly. Refer to Evaporative Emission Control System Diagnosis
.
- If a condition is found replace the affected component.
IMPORTANT:
The EVAP canister assembly contains passages and internal valves that need to be tested for blockage and restrictions.