LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 1.8L (Lay) - Introduction) >> Repair Instructions >> Fuel Pressure Gage Installation and Removal >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Relieve the fuel pressure. Refer to the Fuel Pressure Relief .
    2. Fig 1: Fuel Pressure Gage
    GM320792Courtesy of GENERAL MOTORS CORP.
  2. Remove the J 34730-1A  from the J 42982  . See Special Tools .
  3. Using the J 43178  , disconnect the quick connect coupling of the J 42982  from the fuel feed pipe of the fuel rail. See Special Tools . Use a shop towel in order to catch any remaining fuel that may leak.
  4. Disconnect the quick connect coupling of the fuel feed hose from the J 42982  , and remove the adapter. See Special Tools . Use a shop towel in order to catch any remaining fuel that may leak.
    5. Fig 2: Connecting Quick-Connect Fitting
    GM624247Courtesy of GENERAL MOTORS CORP.
  5. Connect the quick-connect fitting of the fuel feed hose (1) to the fuel feed pipe (2) of the fuel rail. Refer to Metal Collar Quick Connect Fitting Service .
  6. Install the cover for the quick connect coupling of the fuel feed hose.
    7. NOTE: Refer to Fastener Caution .
  7. Connect the negative battery cable.

    Tighten:  Tighten the retainer for the negative battery cable terminal to 15 N.m (11 lb ft).

  8. Turn ON the ignition in order to pressurize the fuel system.
  9. Turn OFF the ignition.
  10. Check for any fuel leaks.
  11. Install the engine cover.
scientia non olet · About LEMON Manuals