LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 1.8L (Lay) - Introduction) >> Repair Instructions >> Fuel Injector Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Fuel Injector Assembly
    GM2016651Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel injector assembly.
  2. Install a new injector vibration insulator to the fuel injector assembly.
  3. Apply a light coat of oil to the contact surfaces of the O-ring of the fuel injector assembly.
    4. Fig 2: Turning Fuel Injector Assembly Left And Right
    GM2016654Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not twist the O-ring. After installing the fuel injectors, check that they turn smoothly. If not, replace the O-ring with a new one.
  4. While turning the fuel injector assembly left and right, install it onto the fuel delivery pipe sub-assembly.
  5. Install the fuel injection fuel rail assembly. Refer to Fuel Injection Fuel Rail Assembly Replacement .
scientia non olet · About LEMON Manuals