LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 1.8L (Lay) - Introduction) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Duty Vacuum Switching Valve Screw
    GM2016485Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Caution .
  1. Install the duty vacuum switching valve with the screw.

    Tighten:  3.4 N.m (30 lb in)

    2. Fig 2: Identifying Duty Vacuum Switching Valve Connector, Vacuum Hoses And Wire Harness Clamp
    GM2016483Courtesy of GENERAL MOTORS CORP.
  2. Connect the duty vacuum switching valve connector, 2 vacuum hoses and wire harness clamp.
  3. Install the engine cover. Refer to Engine Cover Replacement .
scientia non olet · About LEMON Manuals