LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 1.8L (Lay) - Introduction) >> Repair Instructions >> Engine Coolant Temperature Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Drain the engine coolant. Refer to Cooling System Draining and Filling .
  2. Remove the engine cover. Refer to Engine Cover Replacement .
  3. Remove the air cleaner cap sub-assembly with hose.
    4. Fig 1: Locating Engine Coolant Temperature Sensor Connector
    GM2016647Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the engine coolant temperature sensor connector.
    5. Fig 2: View Of Engine Coolant Temperature Sensor
    GM2016648Courtesy of GENERAL MOTORS CORP.
  5. Remove the engine coolant temperature sensor.
scientia non olet · About LEMON Manuals