LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 1.8L (Lay) - Introduction) >> Repair Instructions >> Camshaft Position Sensor Replacement - Intake >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the engine cover. Refer to Engine Cover Replacement .
    2. Fig 1: Locating No. 1 Camshaft Position Sensor Connector
    GM2016629Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the No. 1 camshaft position sensor connector.
    3. Fig 2: View Of No. 1 Camshaft Position Sensor Bolt
    GM2016630Courtesy of GENERAL MOTORS CORP.
  3. Remove the bolt and No. 1 camshaft position sensor.
scientia non olet · About LEMON Manuals