LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 1.8L (Lay) - Introduction) >> Repair Instructions >> Camshaft Position Sensor Replacement - Exhaust >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Applying A Light Coat Of Engine Oil To O-Rings On No. 1 Camshaft Position Sensor
    GM2016633Courtesy of GENERAL MOTORS CORP.
  1. Apply a light coat of engine oil to the O-rings on the No. 1 camshaft position sensor.
    2. Fig 2: View Of No. 1 Camshaft Position Sensor Bolt
    GM2016628Courtesy of GENERAL MOTORS CORP.
  2. Install the No. 1 camshaft position sensor with the bolt.

    Tighten:  Tighten the bolt to 10N.m (7 lb ft)

    3. Fig 3: Locating No. 1 Camshaft Position Sensor Connector
    GM2016626Courtesy of GENERAL MOTORS CORP.
  3. Connect the No. 1 camshaft position sensor.
    4. Fig 4: Identifying Duty Vacuum Switching Valve Connector And Engine Wire Harness Clamps
    GM2016625Courtesy of GENERAL MOTORS CORP.
  4. Connect the 3 engine wire harness clamps and duty vacuum switching connector.
  5. Inspect for oil leaks.
  6. Install the engine cover. Refer to Engine Cover Replacement .
scientia non olet · About LEMON Manuals