LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 1.8L (Lay) - Introduction) >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Accelerator Pedal Position Sensor Components
    GM2016531Courtesy of GENERAL MOTORS CORP.
  1. Remove accelerator pedal assembly.
  2. Disconnect the accelerator pedal position sensor connector.
  3. Remove the 2 bolts and accelerator pedal.
scientia non olet · About LEMON Manuals