Rear Seat Back Cushion Replacement

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Seat Back Cushion & Bolt

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the rear seat cushion. Refer to Rear Seat Cushion Replacement .
1	Rear Seat Back Cushion Bolt CAUTION: Refer to Fastener Caution . Tighten 45 N.m (33 lb ft)
2	Rear Seat Back Cushion Procedure Insert a flat-bladed tool between the top of the rear seat back and the rear shelf. Push the flat-bladed tool down to release the four retainers in order to remove the rear seat back. Disconnect the electrical connectors, if equipped.

Callout

Component Name

Preliminary Procedure
Remove the rear seat cushion. Refer to Rear Seat Cushion Replacement .

Rear Seat Back Cushion Bolt

CAUTION:

Refer to Fastener Caution .

Tighten
45 N.m (33 lb ft)

Rear Seat Back Cushion

Procedure

Insert a flat-bladed tool between the top of the rear seat back and the rear shelf.
Push the flat-bladed tool down to release the four retainers in order to remove the rear seat back.
Disconnect the electrical connectors, if equipped.