LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 97 (Seat Hardware, Seat Trim, And Upholstery) >> Repair Instructions >> Driver or Passenger Seat Replacement

Driver or Passenger Seat Replacement

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Seat Assembly & Bolts
GM1572347Courtesy of GENERAL MOTORS COMPANY
Driver or Passenger Seat Replacement

Callout Component Name

Preliminary Procedures

  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Disconnect the seat belt from the front seat. Refer to Seat Belt Retractor Pretensioner Replacement - Front .
1 Front Seat Assembly Bolt (Qty: 2)
CAUTION:

Refer to Fastener Caution .

Procedure

  1. Adjust the seat to the full forward position to gain access to the rear bolts.
  2. Remove the rear adjuster trim covers to access the bolts.

Tighten 
45 N.m (33 lb ft)
2 Seat Assembly

Procedure

  1. Tilt the seat forward and lift up to release the front of the seat, recline the seat back if needed for clearance.
  2. Disconnect the electrical connectors.
scientia non olet · About LEMON Manuals