Circuit/System Description

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

The passenger presence system (PPS) uses a silicone filled sensor pad located underneath the passenger seat foam cushion and is connected by a hose clamp to the passenger presence sensor. The weight of the occupant sitting in the front passenger seat is measured as a pressure change within the bladder by the passenger presence sensor. The passenger presence sensor is a 3-wire sensor consisting of a high and low reference, and signal circuit. The passenger presence module monitors the passenger presence sensor signal circuit and if a fault is detected, DTC will be set. When the passenger presence module detects this DTC it will send out a serial data message and the SDM will notify the customer of the enable/disable status by requesting the instrument panel cluster to illuminate the OFF indicator on the PASSENGER AIR BAG ON/OFF indicators. The SDM will then suppress the deployment of the passenger instrument panel air bag and illuminate the AIR BAG indicator.