Installation Procedure
WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
- Insert the reveal molding (3) to the pillar.
- Install the screws (2) to the reveal molding (3).
Tighten: Tighten the screws to 2 N.m (18 lb in).
- Tuck the rubber extension under the fender.
- Install the weatherstrip (1) to the windshield pillar flange.
CAUTION:
Refer to Fastener Caution
.