LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Fixed & MOVEABLE Window System) >> Diagnostic Information and Procedures >> Power Windows Malfunction >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Rear Window Switch

  1. Ignition OFF, disconnect the harness connector at the appropriate rear window switch.
  2. Test for 8.0K-9.0K ohms between the signal terminal 4 and the voltage reference terminal 3 with the switch in the inactive position.
    • If not the specified value, replace the rear window switch.
  3. Test for 2.75K-3.75K ohms between the signal terminal 4 and the voltage reference terminal 3 with the switch in the Auto DOWN position.
    • If not the specified value, replace the rear window switch.
  4. Test for 5.25K-6.25K ohms between the signal terminal 4 and the voltage reference terminal 3 with the switch in the DOWN position.
    • If not the specified value, replace the rear window switch.
  5. Test for 1.9K-2.9K ohms between the signal terminal 4 and the voltage reference terminal 3 with the switch in the UP position.
    • If not the specified value, replace the rear window switch.
scientia non olet · About LEMON Manuals