Jack Stands
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Under the Frame Rails
NOTE:
The jack stands must not contact the rocker panels, the front fenders or the floor pan.
Position the jack stands as follows:
Under the frame rail reinforcements.
Under the Front Suspension Crossmember
Position the jack stands as follows:
- Spanning at least two of the (front suspension crossmember) rear reinforcement ribs (preferred location).
- Spanning both of the (front suspension crossmember) front reinforcement ribs (optional location).
Under the Rear Suspension Crossmember
NOTE:
The jack stands must not be placed under the (rear suspension crossmember) front reinforcement rib.
Position the jack stands as follows:
Spanning both of the (rear suspension crossmember) rear reinforcement ribs.