Frame Contact Hoist
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Front Hoist Pads
NOTE:
The front hoist pads must not contact the rocker panels, the front fenders, or the floor pan.
Position the (frame contact) front hoist pads as follows:
- Under the front frame rail reinforcements.
- The long sides of the pads parallel to the frame rails.
Rear Hoist Pads
NOTE:
The rear hoist pads must not contact the rocker panels to the outside of the frame rail reinforcements.
NOTE:
The rear hoist pads must not contact the floor pan.
Position the (frame contact) rear hoist pads as follows:
- Under the rear frame rail reinforcements.
- The long sides of the pads perpendicular to the frame rails.
- The outer edge of the pads aligned with the outer edge of the rear frame rail reinforcements.